Jump to content

There is a problem with installing the k20 coil, I use g4+civic link96, and my engine is b18cr

Recommended Posts

3 minutes ago, Adamw said:

Yes, try adding or subtracting 360deg from your present trigger offset.  You may be sparking on exhaust stroke rather than compression stroke.

Can you help me confirm that my wire signal is correct? Igt (+5vol) I insert the ecu, the ground I install the screw of the distributor,the +12v I use the blk/yel cable of the distributor. Is this method correct?



Link to post
Share on other sites
33 minutes ago, Adamw said:

Yes your wiring sounds correct 

Thank you for your confirmation. Why does my coil1 become hot and cause damage? Could it be caused by incorrect trigger offset? My trigger offset is now -85. I read the previous comments and they put it around 274. Is this correct?
Link to post
Share on other sites
17 hours ago, Adamw said:

The only thing that can make the coil heat is either wrong wiring, or the spark edge is set wrong like I mentioned in the first post.

My engine can work normally, but the rpm can't work. I know I need to add tacho booster to operate it. I want to know if I can use this in the photo to operate it?


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...