Tkymik Posted December 26, 2020 Report Share Posted December 26, 2020 Installed a Link G4+ extreme wire-in ecu on my evo 6 wired in parallel with the oem ecu. I'm using the base map provided by Link for evo 6. Double checked wiring and everything is connected correctly. No error codes, run time values trigger1 and 2 indicates yes when cranking and shows 150-200rpm's. When doing ignition test there is spark. But when I crank it there is no spark. I may have missed something and hope you guys can give me some inputs. I'm attaching a copy of my calibration file, Trigger scope. cranking.mp4 ignition test.mp4 johan evo 6 parallel wire iat off nb off.pclr Quote Link to comment Share on other sites More sharing options...
Tkymik Posted December 27, 2020 Author Report Share Posted December 27, 2020 Nevermind got it running. Turned off ecu hold power Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 27, 2020 Report Share Posted December 27, 2020 If you haven't wired for ecu hold power then you should also set the stepper motor to reset at key on and give it a few seconds to reset every time before starting . Quote Link to comment Share on other sites More sharing options...
Tkymik Posted December 27, 2020 Author Report Share Posted December 27, 2020 Thanks for pointing that out. I do not need to wire anything correct? I just need to set the stepper reset key-on under idle speed control. Lastly in wiring the stepper motor. Is this correct? Thank you. Aux 5 - pin 4 (ISC A1) Aux 6 - pin 17 (ISC A2) Aux 7 - pin 5 (ISC B1) Aux 8 - pin 18 (ISC B2) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.