FunJam Posted December 27, 2020 Report Share Posted December 27, 2020 Hi! I try to control starter solenoid with AUX 7. DI 2 and DI 7 are switches. In "SW Cond 1 " only DI2 I find, is speed below and speed above. Same in DI 7. And they are not working way I want? So, is there better way set this up? DI2 = active + DI 7 = active, then Aux 7 is ON Quote Link to comment Share on other sites More sharing options...
dx4picco Posted December 27, 2020 Report Share Posted December 27, 2020 the value of the DI that you want is Digital input 2 (or 7) (Status) in the parameter selection list. not the speeds. then use equal sign and active state of the DI like this: https://drive.google.com/file/d/1Ehh8chBFnzb-erdzMh3qPM1rK4RFOX5N/view?usp=sharing Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 28, 2020 Report Share Posted December 28, 2020 There is a dedicated starter control function in the chassis and body menu. That will probably do what you want with less fuss. Quote Link to comment Share on other sites More sharing options...
FunJam Posted December 29, 2020 Author Report Share Posted December 29, 2020 dc4picco, I tried to use Aux 7 as a GP output, and there was no option "DI2 status" in list. I used Starter Control function, as Adam advised. I tried it earlier, but I didn't configure DI2 as start position. Now it works. DI 7 (engine run) I configured as Antiteft , so it works also. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.