AEWON Posted December 27, 2020 Report Share Posted December 27, 2020 Hi all, so I’ve got an Nissan S14 with a plug-in and a C125 motec dash, I’ve managed for the most part using the template to get both communicating OK (there’s a few data streams I just can’t seem to get the decimal points correct and I’m yet to master adding a new channel on its own or editing a pre populated template channel) For some reason my Factory dash board speedometer no longer works, I’ve check all my wiring and can’t fault. So Base Map shows no Vehicle Speed and default Digital Input for VSS according to the Link Installation manual is DI 2 and in my Base map DI 2 is Start position, I’d simply prefer to get the Motec Dash displaying Vehicle speed, template only shows 4 x wheel speed no VSS, mine has no ABS. Would like some pointers on setting it up please. Cheers Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 28, 2020 Report Share Posted December 28, 2020 The speed sensor is DI2 on the S13 ecu. If you have start position on DI 2 it sounds like you have the 64pin base map loaded. So, set DI2 to LR wheel speed and it should work in both the ecu and dash. Quote Link to comment Share on other sites More sharing options...
AEWON Posted December 28, 2020 Author Report Share Posted December 28, 2020 Cheers, I knew it would be straight forward! Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.