ZipTieTECH Posted December 30, 2020 Report Share Posted December 30, 2020 Hey guys, I have an NS15+ and I wanted to get a little help on my first start up. I need help with my injector settings but im not sure how the fuel main works. I have ID1050X injectors and have already entered in my Short Pulse Width Adder, Injector Dead time and Minimum affected pulse width from the settings from Injector dynamics and now I am trying to understand the Master Fuel. I am reading the manual and it says "Master should be set so that the numbers in the middle of the fuel table end up around a value of 50. This is to allow sufficient span of the numbers in the main fuel table." Am i suppose to make these adjustments with the car running? I am setting up the base tune on the computer with the car not connected and i am messing with the master fuel but the table doesnt change. Also, is the middle of the table the blue portion of the fuel table? (attached photo for reference of the "blue" portion) Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 30, 2020 Report Share Posted December 30, 2020 Set it to 10ms will be close enough to get it started then tweak it once running if required. Quote Link to comment Share on other sites More sharing options...
ZipTieTECH Posted December 30, 2020 Author Report Share Posted December 30, 2020 Will do. Thank you for the help! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.