280SE 0 Posted January 13 Report Share Posted January 13 Heya, I’ve plugged my G1 controller into the ECU but the screen isn’t readable? Any ideas? running a 1UZ thanks in advance Quote Link to post Share on other sites
Adamw 1,020 Posted January 13 Report Share Posted January 13 Two possibilities: Check the small black wire on the ecu plug (signal ground) still has a good earth. 2nd most common cause is a fractured solder joint at the ribbon cable header to PCB junction - could be either the hand controller end or ECU end. You can send it to us for inspection and repair if you like. Quote Link to post Share on other sites
280SE 0 Posted January 14 Author Report Share Posted January 14 Ok that sounds good, where/who do i send it? Thanks estimate to repair? Thanks Quote Link to post Share on other sites
Adamw 1,020 Posted January 14 Report Share Posted January 14 Fill out and submit a tech support request with some basic detail here: https://linkecu.com/about/contact/ A basic repair and service usually falls under the minimum service charge which I believe is NZD150. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.