Difficulty performing Trigger Calibration procedure with PCLink, G4+ Fury

[Pete_89t2]

Some background - I've got a series 6 RX7 that is running a G4+ Fury, and its using the OEM VR trigger wheel & VR sensors. The car's previous owner originally did the trigger calibration procedure, but I'd like to be able to verify it to ensure it's correct, so I set out to follow the rotary trigger calibration procedure as described in the help file.

Following that procedure, after I hit "Set Base Timing" in the calibrate menu, the set base timing window opened up as it should and I can change both the "Lock Ignition Timing" and "Adjust Offset" values, but any change made here appears to do nothing to the actual timing when cranking & verifying with a timing light - it appears my base timing doesn't change even when I change these settings in the "Set Base Timing" menu. Appears these settings are locked somehow, how would I go about unlocking them?

Thanks!

 

[Vaughan]

In the base timing window did you press Enter after putting in a value? 

[Pete_89t2]

1 hour ago, Vaughan said:

In the base timing window did you press Enter after putting in a value? 

Hmmm, I'm pretty sure I did, but I'll try the procedure again later when I'm back to the garage and let you know how it goes

[Adamw]

The text should turn blue if you've hit enter.  

[Pete_89t2]

Thanks gents, it seems I did forget to hit "enter" after making the changes yesterday - re-did the procedure and all is good now! Surprised my motor was running as well as it was, as the trigger cal done by the previous owner was about 8~10* more advanced than it should have been.