lilmie28 Posted January 27, 2021 Report Share Posted January 27, 2021 Hi, I recently changed to a plug in Link g4X for the mitsubishi evo 9. Stock engine and intake. Less forged block, Td06 22g turbo(stock location with upgraded actuator), exhaust system and 1100cc injectors. Am facing 2 issues and unsure if they are related. 1. I experienced near stalling whenever i downshift from 4-3 or 3-2 in slow speed. And also when i put to neutral before coming to a stop, engine tends to drop rpm to the point of stalling. i need to blip throttle everytime to prevent this. this does not happen when higher revving. 2. In slow speed, (in gear 3 and 4, RPM below 2000), car tends to jerk when gas is not applied. I have tried adjusting but issue still is there. Attached is my mapping. 3067X V5.pclx Quote Link to comment Share on other sites More sharing options...
Vaughan Posted January 27, 2021 Report Share Posted January 27, 2021 could you also attach a log of these issues please I would start by giving it a dashpot value but I'm not sure what this value should be for your setup, maybe 5%? Quote Link to comment Share on other sites More sharing options...
lilmie28 Posted January 27, 2021 Author Report Share Posted January 27, 2021 PC Datalog - 2021-01-27 5;26;33 pm.llgx here is my log PC Datalog - 2021-01-27 5;12;28 pm.llgxPC Datalog - 2021-01-27 5;15;05 pm.llgx Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 27, 2021 Report Share Posted January 27, 2021 Try the map attached below. The main problem in yours was the MAP lockout set to zero so idle control was never kicking in. But while I was in there I also changed your idle control to closed loop and to make it more user friendly I changed the stepper reset to key off and made the keep alive time non zero to allow the stepper to reset after key off. I flattened out a few cells in the ignition table around the idle area. Most of your other idle settings look similar to my Evo 7 so I suspect it will work ok now. If not, post a new log. 3067XV6 idle tweaks.pclx Quote Link to comment Share on other sites More sharing options...
lilmie28 Posted January 28, 2021 Author Report Share Posted January 28, 2021 hi Adam. initial drive after loading your map was good. but 2nd drive onwards, car seems to want to stall. in stationary and wen downshift and putting to neutral. attached are the logs. PC Datalog - 2021-01-28 8;38;03 am.llgx PC Datalog - 2021-01-28 8;33;52 am.llgx Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 28, 2021 Report Share Posted January 28, 2021 It looks like your idle base position is now too low. It seems a bit odd that is needs to be open so far, but try something like this: Quote Link to comment Share on other sites More sharing options...
lilmie28 Posted January 28, 2021 Author Report Share Posted January 28, 2021 10 hours ago, Adamw said: It looks like your idle base position is now too low. It seems a bit odd that is needs to be open so far, but try something like this: Tried adjusting to these. Car drove much better now. Thank u so much!! Any recommendations/advice to which parameter to adjust if i wanna refine bit more? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.