Jump to content

Can lambda input


Recommended Posts

What Im getting at is you need to do the continuity test from end to end.  Not each individual cable/extension/adapter seperately. should be testing from the what plug on the ecu to whatever the AEM device connects to at the other end.    

Link to post
Share on other sites
On 4/7/2021 at 7:44 PM, Adamw said:

What Im getting at is you need to do the continuity test from end to end.  Not each individual cable/extension/adapter seperately. should be testing from the what plug on the ecu to whatever the AEM device connects to at the other end.    

I tested from the white plug on the ecu side to the white plug on the wideband controller, it came back fine. 0. So I dont know whats going on why my ecu isn't reading the CAN lambda. 

 

Is there any other setting inside the aem controller that I need to change other then setting the CAN to ID1?

Link to post
Share on other sites
9 minutes ago, 96Evo4.5 said:

Is there any other setting inside the aem controller that I need to change other then setting the CAN to ID1?

No, should be nothing else to it.

Can you attach your current tune again and a short log of it running.

 

Link to post
Share on other sites

i cant upload either the tune or the data log, it says the file size was to large and was skipped. the tune is 434 kb and the data log is like 700kb

 

 

anyways, the tune was loaded previously i do believe, i havent changed it, it was listed as "Devins tune"  I cant run the car currently as the ecu has been disconnected and i was advised by my tuner to not start the car any further, as the over fueling could damage the rings. But i did get a small log from before i dont know if that would help or not, 

Link to post
Share on other sites
1 hour ago, 96Evo4.5 said:

anyways, the tune was loaded previously i do believe, i havent changed it, it was listed as "Devins tune" 

In the last tune you attached was on April 3rd and you still hadnt fixed the mistake Vaughan pointed out earlier, so I wanted to check the current tune.  

If you have already used up your attachment allowance the you can upload it to something like googledrive/onedriove/dropbox etc and share a link here.

Link to post
Share on other sites

https://1drv.ms/u/s!AgPhKN0QVZUGiFABewD2z-Oq6YMg?e=uuLH9e <----Tune link

https://1drv.ms/u/s!AgPhKN0QVZUGiFEljHJR87Sq6nWU?e=UzRVRj <----Older data log link this will be probably pretty useless because it wasnt taken with the current adjustments done. I figured id share it just it case

 

I had adjusted the tune as per what Vaughan had suggested, (change the ID from 1 to 0) the current tune reflects that. 

I dont use 1 drive much, so I hope the link works properly. 

 

Link to post
Share on other sites
4 hours ago, 96Evo4.5 said:

I had adjusted the tune as per what Vaughan had suggested, (change the ID from 1 to 0)

Vaughan said to change it to none.  It should look like below.  

bdsqLDo.png

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...