Jump to content

Line can, Link Extreme and MXG Strada


Recommended Posts

Hello, I have my Xtreme X ECU connected to an MXG Strada display by Can line and everything works perfectly.
How can I add a new line?
I want to show on the display when the launch control is connected.

Link to post
Share on other sites

Go to the CAN builder in RS3, use the import button to import the xc1 file below.  Then go to your dash config in RS3 and change the ECU type to Link "Generic New".  This new file has launch control status included.  

Launch status 0 = Off.  1 = Active.  2 = Inactive.

LINK_Generic New_@20210104_075506_008240.xc1

Link to post
Share on other sites

Correct.  Make sure ecu firmware is at least 6.19.37.  Launch control and various other channels were added to the MXS stream in 6.19.  Just AiM havent updated the dash file yet.  

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...