Wildt267 Posted April 14, 2021 Report Share Posted April 14, 2021 Hello all, I was going to politely ask the fine engineers if they could work the Aem map sensors into the software, or expand the calibration tables from 16 to 17 cells for convenience, as that is how Aem supplies the data. A lot of folks in the U.S. use these sensors. Thanks for your time. Quote Link to comment Share on other sites More sharing options...
Adamw Posted April 14, 2021 Report Share Posted April 14, 2021 A MAP sensor is linear. You only need 2 calibration points. Pick the biggest one and the smallest one from their table. Also, do not use their psi data from their data sheet as that is wrong, the KPa values are correct. The 3.5Bar AEM calibration would look like below: Quote Link to comment Share on other sites More sharing options...
Wildt267 Posted April 15, 2021 Author Report Share Posted April 15, 2021 Got it. Thank you, that was very helpful. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.