Jump to content

When does the ECU start broadcasting CAN data?


hugemikeyd

Recommended Posts

I have been experimenting with my MonsoonX on my desk with a 12V power supply and I am trying to read the CAN data but the ECU doesn't seem to be emitting any data. Once the ECU has been given power, what else needs to happen in order for it to start broadcasting data? I was hoping to be able to read the MAP as well as the voltage it was seeing while the ECU was on my desk.

I am using a Teensy 4.0 along with a SN65HVD230 CAN transceiver. I have confirmed the proper 60ohms on the CAN bus and when i measure the voltage on the CAN bus when the ECU is on, it is stable at 2.44V.

Any advice is appreciated :)

Link to comment
Share on other sites

  • 1 month later...

Circling back on this, it turns out that the CAN interface chip i bought was faulty, I purchased a new one from Digikey rather than eBay and it's working, now to figure out how to properly read and translate the data for my display...

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...