TurboS52 Posted March 14, 2022 Report Share Posted March 14, 2022 Finally got the E throttle all setup and both the APS and TPS sensors are calibrated and finish successfully. As soon as I turn the E throttle from setup mode to ON it throws fault 70 for E throttle 1 MIN %DC limit it says there may be something restricting the throttle plate or the wiring to the motor has been disconnected. I don't know if there is something I need to change in settings to fix this but wiring is all good and everything calibrates just fine. My MIN is set to -90%DC, I tried going up and down 5% but nothing changed. Please let me know if anybody knows how to fix this. Thanks -Mike Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 14, 2022 Report Share Posted March 14, 2022 Attach the tune and a log Quote Link to comment Share on other sites More sharing options...
TurboS52 Posted March 15, 2022 Author Report Share Posted March 15, 2022 Hey Adam, I just figured it out. My map was set to all zero and I think it was jamming the throttle plate closed. Adjusted it to 5 in the cell it was sitting at and it is now fine with no faults. thanks -Mike Quote Link to comment Share on other sites More sharing options...
Adamw Posted March 15, 2022 Report Share Posted March 15, 2022 You should have 0 in the top row of your E-throttle target table. But there should be non-zero values in the idle base position table, so throttle is not sitting hard against the stop. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.