Jamesn Posted July 31, 2022 Report Share Posted July 31, 2022 I recently brought a powertune dash to wire in with my atom, but i have noticed it has a small white 5pin connector and only uses 2 pins on that, but my ecu does not have that style pin on it anywhere(have opened up to see if it was inside). Could i cut the plug of and instal behind the main ecu connector instead or will i need to put them somewhere else? Have attatched a picture of plug and how my way i thought to do. Cheers James Quote Link to comment Share on other sites More sharing options...
Adamw Posted July 31, 2022 Report Share Posted July 31, 2022 That JST connector is for one of our plug-in ECU's. Yes you can connect directly to the main connector. What ecu to you have? Quote Link to comment Share on other sites More sharing options...
Jamesn Posted July 31, 2022 Author Report Share Posted July 31, 2022 Sweet thats good to know. Thought it should be ok but double check before i cut and splice. I have the link g4+ atom. Cheers James Quote Link to comment Share on other sites More sharing options...
Jamesn Posted August 6, 2022 Author Report Share Posted August 6, 2022 Hi all, just another question about setting up powertune display, i have wired in the way above, power on ecu and link but doesnt seem to register. Where it says select ecu it just says "link Generic Dash" for any ecu that resembles a link? Also i have seen on a few other pages you have to connect it on pc link software, have followed the steps under cam setup but still no luck. Is there anything else that i could try that would maybe help? Cheers James Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.