Joy chenn Posted August 21, 2022 Report Share Posted August 21, 2022 I have a gear number sensor working like temp sensor so i try to connect it to temp channel,but i don't know how to calibrate gear number by the ohms. Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 21, 2022 Report Share Posted August 21, 2022 You dont need to use ohms, set it in volts. You can view the volts in each gear in the runtimes screen, analog tab. Quote Link to comment Share on other sites More sharing options...
Joy chenn Posted August 21, 2022 Author Report Share Posted August 21, 2022 7 hours ago, Adamw said: You dont need to use ohms, set it in volts. You can view the volts in each gear in the runtimes screen, analog tab. Thank you Adamw。And furu calculate speed by gear and rpm? Quote Link to comment Share on other sites More sharing options...
Joy chenn Posted August 28, 2022 Author Report Share Posted August 28, 2022 On 8/22/2022 at 12:00 AM, Joy chenn said: Thank you Adamw。And furu calculate speed by gear and rpm? Why analog gear position sensor cann't choose the 10k-ohms internal resistor? In 1k-ohm the voltage dfference between gears is very small. Quote Link to comment Share on other sites More sharing options...
Adamw Posted August 28, 2022 Report Share Posted August 28, 2022 Only AN Temp 1 & 2 have selectable pull-up resistors, AN Temp 3 & 4 are fixed 1Kohm. You can swap your gear pos with ECT or whatever to free up AN Temp 1 or 2. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.