S13Sky Posted September 11, 2022 Report Share Posted September 11, 2022 Hey community I am getting no spark on any cylinders using the test feature. I have r35 coil packs with ignitor bypass harness. Coil pack 2 is a little warm compared to the others I believe I have my board set to the correct jumpers and config for s13 red top. Any help is appreciated, I haven’t drove my car in 2 years and this is the last step.. Quote Link to comment Share on other sites More sharing options...
Adamw Posted September 11, 2022 Report Share Posted September 11, 2022 This would suggest possibly a couple of different issues. Firstly it sounds as though there is a general wiring issue common to all coils - as regardless of jumper settings on that ecu cylinder 1 is always connected to the correct pin, so coil 1 should work regardless of jumper settings provided the wiring is right. Secondly, the coil #2 getting warm may suggest the jumpers are incorrect also. the jumpers affect which header pins Ign 2,3&4 are connected to. Confirm jumpers using the method highlighted below: Quote Link to comment Share on other sites More sharing options...
S13Sky Posted September 13, 2022 Author Report Share Posted September 13, 2022 This happened to be the problem. i did not notice the jumpers. thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.