Tanzeel Posted November 4, 2022 Report Share Posted November 4, 2022 Hi, all I am very new to this link Software, I am struggling to setup my DBW using Bosch Dbw pedal and Bosch throttle body. I have checked my 5 reference, ground, and both signals on the pedal. I have checked the same at the throttle I don’t know if this is a map issue or something I have missed. I can’t see any reason why the throttle shouldn’t be actuating when pressing the pedal down. Any help would appreciated! Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 4, 2022 Report Share Posted November 4, 2022 Does the APS and TPS calibration successfully complete? Attach a copy of your tune and a short log of some pedal presses. Quote Link to comment Share on other sites More sharing options...
Tanzeel Posted November 5, 2022 Author Report Share Posted November 5, 2022 Hi Adam, I can not complete the TPS calibration error number 5 "no TPS main movement" but the APS can be calibrated. supra.pclx PC Datalog - 2022-11-5 2;16;39 pm.llgx Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 5, 2022 Report Share Posted November 5, 2022 Aux 8 is off in that log so there is no power supply to the E-throttle driver. If you temporarily turn the E-throttle relay off and then move the throttle blade with your fingers, do the AN Volt 2 & 3 voltages move? Can you do another log but with the E-throttle in set up mode. Quote Link to comment Share on other sites More sharing options...
Tanzeel Posted November 5, 2022 Author Report Share Posted November 5, 2022 I turned off the relay and moved the blade the an 2 and 3 voltages move under run time value. I also just noticed the e throttle relay is set on inj 8 not aux 8 my tacho is on aux 8 according to my loom pin out file. could you run the e throttle relay of inj8? have attached loom file and another log Old-Loom-Repin.pdf PC Datalog - 2022-11-6 12;56;24 pm.llgx Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 6, 2022 Report Share Posted November 6, 2022 E-throttle relay is set to Aux 8 in the map you attached. You will have to set this to inj 8 if that what is wired to th erelay. Quote Link to comment Share on other sites More sharing options...
Tanzeel Posted November 6, 2022 Author Report Share Posted November 6, 2022 Yes all done all that, still no action Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 6, 2022 Report Share Posted November 6, 2022 Need a log again please. start the log first, then do the TP calibration, then stop and save log after that completes or fails. Quote Link to comment Share on other sites More sharing options...
Tanzeel Posted November 6, 2022 Author Report Share Posted November 6, 2022 done another log both tps and aps aswell PC Datalog - 2022-11-6 7;09;04 pm.llgx PC Datalog aps- 2022-11-6 7;10;30 pm.llgx Quote Link to comment Share on other sites More sharing options...
Adamw Posted November 6, 2022 Report Share Posted November 6, 2022 Inj 8 is still off in that log. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.