lc_fist Posted December 5, 2022 Report Share Posted December 5, 2022 Hello I got my G4X ECU to send the generic dash output to the Motec C2 on CAN 127 - everything works fine. I added fuel level on AN8 on G4X ECU, calibration table 8 sets the calibrated voltage, PCLink shows the fuel level accurately. I add the transport stream to 5, how do I add this channel to the CAN 2 to the Motec, or do I need to go and buy the I/O? Is there an example I can refer to for help? thanks EVO9 Link ECU G4X.c127v61 EVO9 G4X.pclx The value will change slowly according to the pull, I have calibrated Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 5, 2022 Report Share Posted December 5, 2022 Ok, try these. EVO9 G4X V2.pclx EVO9 Link ECU G4X V2.c127v61 Quote Link to comment Share on other sites More sharing options...
lc_fist Posted December 6, 2022 Author Report Share Posted December 6, 2022 I flashed the file in and everything was fine. thank you so much Quote Link to comment Share on other sites More sharing options...
lc_fist Posted December 8, 2022 Author Report Share Posted December 8, 2022 Also I have another question, how can I set the CAN to display the mileage on the MOTEC C127? Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 8, 2022 Report Share Posted December 8, 2022 The C127 has an odometer and trip distance function built in. The ecu already sends wheel speeds to the dash so thats all it needs. Quote Link to comment Share on other sites More sharing options...
lc_fist Posted December 8, 2022 Author Report Share Posted December 8, 2022 I'll load it in and try it out, Thanks again Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.