Jimbostir Posted December 9, 2022 Report Share Posted December 9, 2022 Hi If I go in Ecu statistics, the MAP limit count increases every time I put ign on with engine not running. The map limit table is 2 bar above atmosphere all along the ECT range so it’s not actually reaching map limit. Could this be a software issue? Quote Link to comment Share on other sites More sharing options...
Iguanapeluda Posted December 9, 2022 Report Share Posted December 9, 2022 1 hour ago, Jimbostir said: Hi If I go in Ecu statistics, the MAP limit count increases every time I put ign on with engine not running. The map limit table is 2 bar above atmosphere all along the ECT range so it’s not actually reaching map limit. Could this be a software issue? Yes, mine G4X appears all days the same... Jimbostir 1 Quote Link to comment Share on other sites More sharing options...
Vaughan Posted December 11, 2022 Report Share Posted December 11, 2022 Couple of people have mentioned this recently, update your firmware to 6.22.8 or newer Quote Link to comment Share on other sites More sharing options...
Jimbostir Posted December 15, 2022 Author Report Share Posted December 15, 2022 Hi ok thanks. I will have a look. When had a look, it said I was up to date but il have another look and see what version I’ve got installed. Quote Link to comment Share on other sites More sharing options...
Vaughan Posted December 15, 2022 Report Share Posted December 15, 2022 https://linkecu.com/software-support/pc-link-downloads/ Download the latest PCLink and install the firmware that comes with it. Quote Link to comment Share on other sites More sharing options...
Jimbostir Posted December 15, 2022 Author Report Share Posted December 15, 2022 Hi It would appear that this update isn’t available? Quote Link to comment Share on other sites More sharing options...
Vaughan Posted December 15, 2022 Report Share Posted December 15, 2022 16 hours ago, Vaughan said: https://linkecu.com/software-support/pc-link-downloads/ Download the latest PCLink and install the firmware that comes with it. Quote Link to comment Share on other sites More sharing options...
Jimbostir Posted December 16, 2022 Author Report Share Posted December 16, 2022 Ok thankyou. I did that before going to work. It says you have to confirm base idle timing offset or something so I left it for now. Sounds like it’s a bit involved. Quote Link to comment Share on other sites More sharing options...
Jimbostir Posted December 18, 2022 Author Report Share Posted December 18, 2022 Sorted. I downloaded the latest version of firmware. All good thanks. Base timing was fine too so didn’t need to adjust. Vaughan 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.