JasonK Posted December 21, 2022 Report Share Posted December 21, 2022 Hi Team My Haltech IC-7 is not reading any data from my Link Xtreme ECU. i am using the Haltech cable for the Link G4 Any ideas? I’m a little frustrated i have tried selecting both CAN Termination Resistor enabled and disabled and have the Link G4 protocol selected (infact the cable does that by default). See pic of IC-7 settings. Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 21, 2022 Report Share Posted December 21, 2022 Can you attach the map from your ECU. Is the dash wired to CAN 1 or 2 on the ecu? Quote Link to comment Share on other sites More sharing options...
JasonK Posted December 21, 2022 Author Report Share Posted December 21, 2022 Which map Adam? PC cable connected to ecu port with red ring and dash to the other port Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 21, 2022 Report Share Posted December 21, 2022 The ECU map. I assume you have set up the ecu as per the haltech instructions? Quote Link to comment Share on other sites More sharing options...
JasonK Posted December 22, 2022 Author Report Share Posted December 22, 2022 I’ll connect the laptop to the car on Sat and take a pic of the map. the ecu was set up by MRC and I installed the Ic-7. Do I need to change any settings on the Link Xtreme so it sends data to the dash? will I damage anything if I try reversing the can wires into the dash as a test? Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 22, 2022 Report Share Posted December 22, 2022 11 hours ago, JasonK said: I’ll connect the laptop to the car on Sat and take a pic of the map. I dont want a pic, I want a copy of the map so I can look at your settings. 11 hours ago, JasonK said: Do I need to change any settings on the Link Xtreme so it sends data to the dash? Of course you need to set the ecu up. There are instructions in the Haltech software as I mentioned before. Quote Link to comment Share on other sites More sharing options...
JasonK Posted December 24, 2022 Author Report Share Posted December 24, 2022 Excuse my ignorance Adam I’m a first time user of Link and Haltech (prev motec m48). The link Xtreme CAN set up options mode tab doesn’t have the Mode option “Transmit DiplayLink”. the screen shot shows the only available options. I tried “transmit Generic Dash” and it seems to be working Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 24, 2022 Report Share Posted December 24, 2022 Ah yes sorry. The Displaylink stream was identical to generic dash stream so in G4X we didnt add both. Generic dash is the correct one for you. Quote Link to comment Share on other sites More sharing options...
JasonK Posted December 24, 2022 Author Report Share Posted December 24, 2022 Thanks for all your help. First time users can be a pain. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.