sns00 Posted January 11, 2023 Report Share Posted January 11, 2023 Hello, I'm I the only one unable to see First Crank Prime in the logs, or it will only show in the Parameters List "F12"? I can see everything in the start sequence, except FCP. The log is old, but I've been having the same issue for a long while; checked the logs from this week and I cant see it... Regards. Cold-NoStart.llgx Quote Link to comment Share on other sites More sharing options...
cappo_nz Posted January 11, 2023 Report Share Posted January 11, 2023 In PCLink under the Logging menu, open Setup Logging and check that First Crank Prime is in the list of logged parameters. Quote Link to comment Share on other sites More sharing options...
essb00 Posted January 11, 2023 Report Share Posted January 11, 2023 'First Crank Prime' is just a percentage added to the 'Crank Enrichment' value on first engine rotation (whenever ECU has already detected the trigger sync tooth). You should be able to see the difference in the logged 'Injection Actual PW' during cranking whenever you would change the 'First Crank Prime' percentage. Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 11, 2023 Report Share Posted January 11, 2023 I think this runtime might have been broken along the way somewhere, I just checked on the bench and I only get zero reported with the current firmware, if I roll back to older firmware it works as its meant to. I will have a closer look tomorrow. Quote Link to comment Share on other sites More sharing options...
sns00 Posted January 13, 2023 Author Report Share Posted January 13, 2023 Thank you for the replies. @Cappo_nz, Yes I did check, FCP is in the logged value list for the PC and ECU; I've tried looking at the ECU logs if it makes a difference, I still get 0.00, even looking at the Parameter List live, it reads 0. Quote Link to comment Share on other sites More sharing options...
Vaughan Posted January 17, 2023 Report Share Posted January 17, 2023 On 1/11/2023 at 8:01 PM, sns00 said: Hello, I'm I the only one unable to see First Crank Prime in the logs, or it will only show in the Parameters List "F12"? I can see everything in the start sequence, except FCP. The log is old, but I've been having the same issue for a long while; checked the logs from this week and I cant see it... Regards. Quick Test on the desk and it seems to work for me on the current release, show's how much it's going to inject up until the first crank and then shows zero while running. To confirm does it work in the runtime but not in the log or does it not work in the runtime at all. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.