Tanzeel Posted January 26, 2023 Report Share Posted January 26, 2023 Hi, just bought a Link Can Gauge for my car I wired up the gauge as shown on instructions pin 1 on the Dtm plug going to switched 12v pin 2 going to chassis ground pin 3 going to can L pin 4 going to can H Issue I am having is with the gauge is not powering up at all. I have checked power with my test light behind the gauge plug. Have checked ground wire too. Am I missing something here? Quote Link to comment Share on other sites More sharing options...
Adamw Posted January 26, 2023 Report Share Posted January 26, 2023 Can you unplug the cable from the back of the gauge and confirm you have 12V & Gnd in the #1&2 positions as per photo below. Quote Link to comment Share on other sites More sharing options...
Tanzeel Posted January 27, 2023 Author Report Share Posted January 27, 2023 Hi, Adam I got it sorted My switched feed was tapped into my stereo which was not crimped properly Thanks Quote Link to comment Share on other sites More sharing options...
koracing Posted February 11, 2023 Report Share Posted February 11, 2023 I noticed today on the Link CAN gauge box liner it says "up to 40 configurable screens" - that's a bit misleading as I'm pretty sure it's 10 screens with up to 4 parameters per screen or "up to 40 configurable parameters". Adamw 1 Quote Link to comment Share on other sites More sharing options...
Adamw Posted February 12, 2023 Report Share Posted February 12, 2023 21 hours ago, koracing said: I noticed today on the Link CAN gauge box liner it says "up to 40 configurable screens" - that's a bit misleading as I'm pretty sure it's 10 screens with up to 4 parameters per screen or "up to 40 configurable parameters". Yeah I think you are right. I will pass this on to the relevant team. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.