koracing Posted May 4, 2023 Report Share Posted May 4, 2023 Would really like there to be a override or function to command 0% duty on the IAC when a map level is reached overriding any minimum duty settings in the idle control setup. Obivously only for when there is an actual idle speed control motor attached or enabled. Quote Link to comment Share on other sites More sharing options...
cappo_nz Posted June 9, 2023 Report Share Posted June 9, 2023 The idle base position table *can* be configured as a 3D table - add MAP or MGP to your Y axis and setup from there. Quote Link to comment Share on other sites More sharing options...
dx4picco Posted June 9, 2023 Report Share Posted June 9, 2023 But not with a value under the minimum clamp. Quote Link to comment Share on other sites More sharing options...
koracing Posted June 12, 2023 Author Report Share Posted June 12, 2023 On 6/9/2023 at 2:58 AM, dx4picco said: But not with a value under the minimum clamp. This. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.