gojira Posted April 9, 2015 Report Share Posted April 9, 2015 Hi, i have a Vi-Pec i88 new model. As i noticed it's not possible to adjust in some tables the AXIS setting while i whant it. i am talking about the following tables : injector deadtime vs bat volt short pulse width adder and CAL 7 to 10 is just showing 1 square, not even a 2D table. Are these maybe adjustable when live with ECU ? because that's not a real problem as i can do that. Quote Link to comment Share on other sites More sharing options...
Simon Posted April 10, 2015 Report Share Posted April 10, 2015 Hi The Short adder table is fixed and is not adjustable other than the offset values. The Dead time table is but you will need to set it to a 3D table first through the main fuel configuration. Cal 7-10 is a bug that is in the list to be fixed. Quote Link to comment Share on other sites More sharing options...
gojira Posted April 10, 2015 Author Report Share Posted April 10, 2015 so the injector deadtime 2D table and short adder is not adjustable? 3D deadtime don't need Quote Link to comment Share on other sites More sharing options...
xtra-racing Posted April 12, 2015 Report Share Posted April 12, 2015 Enable 3D table for injector deadtimes, but don't use Y axis (set as none), this way you can configure X axis Quote Link to comment Share on other sites More sharing options...
gojira Posted April 12, 2015 Author Report Share Posted April 12, 2015 will look into that Quote Link to comment Share on other sites More sharing options...
gojira Posted April 20, 2015 Author Report Share Posted April 20, 2015 thnx for that tip Quote Link to comment Share on other sites More sharing options...
Dave Kriedeman Posted April 21, 2015 Report Share Posted April 21, 2015 Hi again, remember please update Firmware Regards Dave. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.