Idle Control LT Learning?

[DerekAE86]

Any thoughts on adding a Long Term learning mode for Idle Control base position so the ECU can dial in on more accurate base position over time?

[koracing]

I would think simply logging it a few times should be enough?

[mapper]

I totally agree, this would make sense. Also, a long term trim function for Wastegate duty cycle would be great. 

[DerekAE86]

I'll just tack onto this thread.

But how about doing away with the min/max clamp for the idle actuator and just setting a scaler instead?

So for example if you have a valve that is fully closed at 15%, any more and it starts to open again. and is essentially fully open at 80%;
You could set 15 duty cycle as "0%/closed" and 80 duty cycle as "100%/open" and when you construct your base idle position and offset tables you only have to think in 0% = closed, 100%  = open.