Liam2ZZ Posted May 23, 2023 Report Share Posted May 23, 2023 Hi folks, I have a G4+ Monsoon and i'm struggling to get Oil pressure and temp to transmit via CAN to a Race Technology dash 2, (not the pro). The CAN adapter is configured to receive both but i can't get it to display. The Oil pressure is on AN Volt 2, and is a link sensor, the Oil temp is on AN Volt 3 but on a 'GP TEMP' as my 2 AN temp channels are full (water and air). Both sensors are reading in the PC Link software, CAN stream in the set up doesn't really show much and I've got no idea what i'm fiddling with so i'm reaching out........ Many thanks in advance. 2zzmap-current.pclr Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 23, 2023 Report Share Posted May 23, 2023 There is no reason why oil pressure shouldn't have worked with the original set up but oil temp wouldnt have. Attached is your MAP with some custom CAN added to send the GP temp in place of oil temp. The problem with oil press must be at the dash or CAN adapter end. 2zzmap-new CAN.pclr Quote Link to comment Share on other sites More sharing options...
Liam2ZZ Posted May 23, 2023 Author Report Share Posted May 23, 2023 Cheers Adam, Very much appreciated. I'm in contact with race technology about this so hopefully this will get resolved sooner rather than later. Car is going for mapping tomorrow and race on 1st July. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.