Stranger24 Posted December 26, 2023 Report Share Posted December 26, 2023 My rpm is off by around 100 , how would one calibrate this and also no speed shown i appreciate any advice here Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 26, 2023 Report Share Posted December 26, 2023 To adjust the tacho, >Auxiliary outputs>tacho> multiplier or offset. For the speed, do you mean the speedo is not working, or there is no speed showing in the ecu software? Quote Link to comment Share on other sites More sharing options...
Stranger24 Posted December 26, 2023 Author Report Share Posted December 26, 2023 Great thanks Re speed no speed is shown on cluster, needle stays on 0 Quote Link to comment Share on other sites More sharing options...
Stranger24 Posted December 28, 2023 Author Report Share Posted December 28, 2023 I sorted the cluster so thanks, would you use the offset or multiplier ? I used the offset. I have a question on speed sensor as cluster shows speed as 0. I logged all values related to speed and can see non of them are picking anything up. see my setup below. any thoughts you have? Quote Link to comment Share on other sites More sharing options...
soondin Posted December 29, 2023 Report Share Posted December 29, 2023 As many as I remember you have to check your DI drop to enough low voltage. If it's not use Diode voltage drop. Quote Link to comment Share on other sites More sharing options...
Adamw Posted December 29, 2023 Report Share Posted December 29, 2023 The ecu will not prevent the speedo from working, the speedo gets its signal from the speed sensor independently from the ecu. Just try it with the pull-up off in case that is affecting the signal. Quote Link to comment Share on other sites More sharing options...
Stranger24 Posted January 1 Author Report Share Posted January 1 Thanks Adam will try and post back Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.