e-throttle Link ECU NGTRX Remote E-Thottle Wiring for RB25DET

[MUSTER]

Hello, this is the first time I have asked a question and I hope to be as detailed as possible.

I have an ECu link NGTRX for a RB25DET s1 and to be able to install the electronic throttle, I have acquired a control module, but I have doubts about how to wire it and I want to know if my wiring configuration is correct.

This is the module:

 

This is the diagram:

Thank you in advance!

PS: I have decided to use these AUX outputs, following these indications:

[Adamw]

Those are old instructions from maybe G4 or a V series.  With G4X the PWM outputs for the RET signal 1/2 must use Aux 1&2 or Aux 3&4. The enable (e-throttle relay) can be any aux, Inj or Ign.  

What revision bottom board do you have?  The current one (V1.7) has Aux 9&10 for direct e-throttle already available on one of the expansion connectors. 

 

[MUSTER]

Thank you very much for your reply.

I just saw, that my lower board is V1.6, which doesn't have the AUX 9/10 for that configuration.

So, as far as I can see, I have to use either AUX1/2 or AUX3/4 for signal 1/2 respectively.

But what about the functions these AUX normally occupy on the original ECU pins?

TYPE	ECU PIN	FUNCTION
AUX 1	113	VTC
AUX 2	104	FP SPEED 1
AUX 3	9	AC OUT
AUX 4	7	TACHOMETER

For example, if I use AUX3/4, do I have to sacrifice it or can I configure other AUX for the tachometer output, like AUX 11 for example?

Thanks!!

[Adamw]

Aux 11 cant do PWM.  Can you move the tacho wire to aux 7?  If you want the CE light you could move that to aux 11 or Ign 7 or 8 on the expansion.