G4+ no spark

[Håvard Karlsen]

Hello, i do not get spark on this. Are these signals wrong? Triggerwheel is 36-1. Spark test is ok. 

[Vaughan]

Your trigger 1 sensor wires are the wrong way around and need to be swapped.

Where is that sensor located, what motor is it and what trigger settings do you have in the ECU?

[Håvard Karlsen]

Its a twstroke 1000 ccm.

The sensor can be seen on the picture. 
we have tried the wires the other way too.

i will post settings tomorrow

[Vaughan]

49 minutes ago, Håvard Karlsen said:

The sensor can be seen on the picture. 

My question about sensor location was referring to camshaft vs crank shaft but that is covered by it being a 2 stroke.

The wires the other way around is the correct way, both ways will give triggers with the right settings but the current wire orientation will give lots of ignition movement due to inconsistent zero crossings on the falling edge.

[Håvard Karlsen]

Turbo M1000.pclr

Here is the ecu files

[Vaughan]

Trigger 2 sync Mode should be set to None. Can you take a short PC Log of you attempting to start it and attach it here please.

To confirm if you have a spark plug outside of the engine connected to a coil with the spark plug threads earthed you can see a spark on ignition test but not when cranking? What ignition coils are you using and are they smart or dumb coils?

[Håvard Karlsen]

Its smart coils. Spark is ok on tests, no spark while cranking. I will log later to day.

PS! got spark when ther trigger 2 was set to none. Thanks