ethrottle g4x setup

[team claymore]

Hi i have read through everything i could see relative to my issue and made changes but still need some assistance. I can get throttle to move when doing tps calibration but thats the only time it will move.  im using a bosch throttle body 82mm and bosch pedal # 0280 755 051.  New to using link  so i may need instructions on how to send you the file for you to look at it. i also have a list of pin location see below:

an volt 5 pedal 1

an volt 6 pedal 2

an volt 7 tps main

an volt 11 tps sub

 

I had the ecu sent off for ethrottle upgrade, i have also done a firmware upgrade too.

 

 

 

 

Link Clazzo.pclx

[Adamw]

Your E-throttle target table should have APS on one axis, you currently have TPS.  

[team claymore]

16 hours ago, Adamw said:

Your E-throttle target table should have APS on one axis, you currently have TPS.  

I see thank you. Where do I change this setting? 

[Vaughan]

right click on the table, Axis Setup. Or select table and press the X key.

[team claymore]

all sorted !! thank you