WRX11X CAN Bit Rate Question

[ae82ted]

Hi,

We are trying to connect the AiM Solo2 DL to the WRX11X ECU on CAN1, but at the same time we have also connected the AEM X-Series Wideband O2 on CAN1. The Wideband sensor runs on 500k bit rate but the Solo 2DL runs on 1M Bit rate. We can't make both devices running at the same time. Is there any way to solve this issue?

If we set the baud rate at 500k the WBO2 works but not the Solo DL, if set as 1M the solo works but not the WBO2

 

[David Ferguson]

Why can't you configure the Solo2 DL communications for 500kb?    You can recreate the CAN Protocol in Aim Race Studio3 to work at whatever baud rate you wish.

[Adamw]

There is a pre-configured "ECU stream" in race studio 3 for 500K.  Named something like "500 Base LCC"

[ae82ted]

Thanks! I didnt know the 500 Base LLC is for 500 bit rate. Will try that out. Thanks!