Fj20 xf8hp Posted October 2, 2024 Report Posted October 2, 2024 Hi there, I am looking at tuning can for cuts and blips with g4x monsoon not sure what values to start with in e throttle table2 etc Can anyone start me in the ballpark? Cheers Mike Quote
Fj20 xf8hp Posted October 3, 2024 Author Report Posted October 3, 2024 Bad post sorry,early morning I am using cantcu and have configured the link ecu according to the canwiki and looking for starting values for throttle table 2 Has DBW throttle There is a lot of info in the can help files but not much I could find on automatic gearbox integration Should it be treated like a DCT or sequential ? Thanks Quote
David Ferguson Posted October 3, 2024 Report Posted October 3, 2024 you might look at this thread for some insight on integrating CANtcu: Quote
Fj20 xf8hp Posted October 5, 2024 Author Report Posted October 5, 2024 Thank you David, It looks as though the blip request is fairly straightforward The cut looks to be more intimidating,Am I correct to assume the CAN shift request is done by completing the torque request table? Or is there another way? I apologise for the simple questions,I am just trying to understand what is required Cheers Mike Quote
Adamw Posted October 5, 2024 Report Posted October 5, 2024 That linked post was for a G4+ which is more restricted in options for a variable cut commanded via CAN, but still a lot of it will apply. G4X has a few more options though. Doing a full torque management model would be the ultimate, but is pretty daunting so I would suggest keeping it more basic to start with, only add complication when it is really needed. I believe the 8HP is pretty forgiving from a torque reduction point of view. Support requests for help interfacing with CAN TCU and Turbolamik have been getting more common recently and both of their documentation seems to be quite lacking so I have been meaning to put together some more detailed instructions to make it easier. I should be able to look at this in the next week or so if you can wait a bit. Quote
Fj20 xf8hp Posted October 5, 2024 Author Report Posted October 5, 2024 That sounds great thank you Adam I think once people experience these conversions they will only become more popular Looking forward to your input Cheers Mike Quote
Fj20 xf8hp Posted October 12, 2024 Author Report Posted October 12, 2024 I have done some searching around and found this. Would this be a good place to start? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.