Levon Luther Posted May 25, 2013 Report Share Posted May 25, 2013 Hi Simon and the rest of the link team - With the amount of people adding in E85 these days, do the PnP Link boards have the hardware capabilities to have another Trim for target boost / WGDC? It would be cool to have the table so if you have an ethanol sensor hardwired in, it can adjust boost for bad E85 on the fly. ( Say in winter you get E70, it knocks out 3psi boost or something along those lines ) I'm getting prepped for my E85 tune and just was thinking of what would be better than carrying around an E85 tester. Thanks Levon Quote Link to comment Share on other sites More sharing options...
Adamw Posted May 25, 2013 Report Share Posted May 25, 2013 You can do something similar using 'multiple boost tables' and switch them using virtual aux's. There's a few different ways that you could do it but you could have say 'Boost table 1' set up with your full E85% boost levels. Then you would set up a virtual aux to that turns on when say ethanol content is between 72%-80% - use this to switch over to 'boost table 2' which would be a medium boost table. Set up another virtual aux for say <= 72% ethanol and use that to switch on 'boost table 3' - which is your low boost settings. Quote Link to comment Share on other sites More sharing options...
simon gottlieb Posted May 27, 2013 Report Share Posted May 27, 2013 Could you also just change the axis in the active boost table of ethanol vs rpm? So on the x axis have ethanol from 0- 85 and on y have rpm? Would this work instead of having to setup virtual axis' and such? Quote Link to comment Share on other sites More sharing options...
Levon Luther Posted May 27, 2013 Author Report Share Posted May 27, 2013 The problem with doing it the way that AdamW Mentioned is the limited tables for the PnP Link box. I only have 12 tables and they get chewed up quick. See attached for what I have; and I dont feel like anything can go. The way you said simon would be a good one, at first thought I didn't like it until I looked at my current boost table (also attached) so the throttle position really isn't doing much right now. I'd be better off having it be oil temp for target boost or something so that I dont boost when oil is still chilly. I wish I had enough tables to add a 4D fuel / Ignition map so that I could have full flex fuel capabilities without having the computer with me. Quote Link to comment Share on other sites More sharing options...
Kelly Gordon Posted May 29, 2013 Report Share Posted May 29, 2013 Hey Leyvon.  You can do something like this and it would not require any more tables. Your boost target will automatically change based on ethanol content and all you need is one WGDC table that spans all intended boost levels. Quote Link to comment Share on other sites More sharing options...
Levon Luther Posted May 30, 2013 Author Report Share Posted May 30, 2013 That would be a good idea. K.I.S.S. It makes a good safety that way. Right now my TB map is pretty much a 2D Map because 20%TPS spits out the same boost target as 100% for any given RPM. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.