G4X FuryX Internal Lambda Stuck at 0

[Flat6gc8]

Hi,

My Lambda reading is stuck at zero. Wiring is all good. I have tested the resistance between the MES and APE wires in the B loom, and it showed 110 ohms. Is there something I am missing in my tune? 

Car is an EZ30r into a GC8 WRX.

Log file down below.

Thanks.

wrx 2911 no lambda.pclx

[Flat6gc8]

PC Datalog - 2024-11-30 10;30;28 am NO LAMBDA.llgx

[Adamw]

In your log you can see it starts to heat at around 30sec just before you turned it off, so from that it appears like it is working as expected.  Can you run it for longer, or temporarily set the Lambda to "run when stalled" to confirm it heats and reaches operating status without error.  You can watch Lambda 1 temp and Lambda 1 status in the runtimes screen - ecu status tab.

[Flat6gc8]

Thanks Adam. 
 

Ran the car for a bit longer and started to get a reading. 
 

cheers