Incognito G Posted June 30, 2009 Report Share Posted June 30, 2009 I'm not sure what ecu to chose, but I will be installing this on an Evolution 3 with the following mods: 750cc FIC Injectors (Low Impedance) GM Boost Controller GM 3 Bar Map Sensor Mitsubishi 6 Wire Stepper Motor AC Clutch My main concern would be will the Storm have enough outputs (i understand there are 8 but it includes the tach etc) and will it be able to drive the Injectors? What made you chose the Exterme over the Storm? Cheers! Quote Link to comment Share on other sites More sharing options...
Guest Dave Posted June 30, 2009 Report Share Posted June 30, 2009 Do you want to wire it in or will a pluggin ecu do the job as Link do a G4 pluggin for your particular car the only reason to chose the between the Storm and Extreme would be if you need the extra in and outputs and if you dont want to use the factory injector ballast resistors as the Extreme can drive low impedance injectors directly where the Storm requires a ballast to be fitted just like the factory ecu did Regards Dave [email protected] Quote Link to comment Share on other sites More sharing options...
Incognito G Posted June 30, 2009 Author Report Share Posted June 30, 2009 Thanks Dave. Would a 10 Ohm 10 Watt resistor wired inline to the injector outputs of the Storm work? I'd like to go away with the OEM Injector Ballast. Quote Link to comment Share on other sites More sharing options...
Simon Posted July 1, 2009 Report Share Posted July 1, 2009 You will actually require 4.7ohm 25Watt resistors. One per injector. Quote Link to comment Share on other sites More sharing options...
Incognito G Posted July 1, 2009 Author Report Share Posted July 1, 2009 Thanks Simon. Will look into this Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.