Map sensor calibration ECU plug In

[Bud]

Dear all

I have one ECU Link plug in for Subaru v5 & V6.

I use all sensor standard from subaru.

I can not make MAP sensor calibration by the software.

i have this error message :

MAP SENSOR CALIBRATION COMMAND FAILED: CURRENT MAP inf 5KPA or sup 5KPA OF BARO READING.

Can you help me? because i have delay when i check boost pressure Defi gauge and the  on the link software.

Regards

Ludo

 

[Scott]

Hi Ludo,

Two things you can check.

1. If you go to the AN Volt channel you have the MAP sensor on, make sure you have the right calibration selected.

2. Go to the Analog fault settings (at the bottom of the Analog Inputs section) and check the settings for the AN Volt channel you have the MAP sensor on. Typical values would be:

    AN Volt X High: 4.95v

    AN Volt X Low: 0.05v

    AN Volt X Fault setting: 100 kPa.

Cheers,

Scott

[Scott]

Hi again Ludovic,

Which firmware version is your ECU running on? You can this out by looking under Help > ECU information

Cheers,

Scott.

[Bud]

Dear Scott

My firmware version is 4.9.1

Regards

Ludovic

[Simon]

Hi Ludovic

Try using the V7-9 map sensor option and see if it will let you perform the calibration.

Some of the later V6 models were fitted with the later map sensor.

[Bud]

Hi Simon,

I test with calibration V7-V9 map sensor.

And it will be working and i can calibration with success

Thank you in advance

regrads

Ludo