ken1436215443 Posted March 5, 2013 Report Share Posted March 5, 2013 I want to use the AEM 5 bar for map sensor. Is the link 5 bar map sensor setting good enough or should i recalibrate it ? I also want to use the GM Intake Temp Sensor. does link have a preset calibration for this sensor also ? Help would be great Quote Link to comment Share on other sites More sharing options...
Scott Posted March 6, 2013 Report Share Posted March 6, 2013 Hi Ken, Is this the sensor you have? http://www.aemelectronics.com/5-bar-75-psia-map-stainless-steel-sensor-kit-655 I would recommend entering the calibration information AEM supply into a calibration table, then use that cal table for your MAP sensor. Scott Quote Link to comment Share on other sites More sharing options...
Scott Posted March 11, 2013 Report Share Posted March 11, 2013 Hi again Ken, GM vehicles have used a range of IAT sensors over the years. I know some of them have used Delphi sensors. I would recommend wiring up the sensor, configuring it as IAT and then try the different calibrations available and see if the IAT reads what you expect. If none are correct you will need to find and enter the information to a custom calibration table. Scott Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.