Sebastian Larsson Posted August 10, 2011 Report Share Posted August 10, 2011 Hello!  I get no signal from DI1 and DI2 (VVT Cam Position) What should i do to get the Cam control to works? Quote Link to comment Share on other sites More sharing options...
Jurgen Biggelaar Posted August 12, 2011 Report Share Posted August 12, 2011 Hi Sebastian. You first need to confirm the wires are going to the correct place on your pin out. Then to double check your settings in line with what the manual/help file says. If you attach a copy of the map I can see if there is anything obvious that may be not set correctly. This is most likely how your set up should look on those DI's... http://i903.photobucket.com/albums/ac236/linkelectro/camcontrol.jpg Jurgen Quote Link to comment Share on other sites More sharing options...
Sebastian Larsson Posted August 14, 2011 Author Report Share Posted August 14, 2011 Hello! Â I have look in the wiring diagrams but i only find the cam position sensor to trigger2 on left intake camshaft, im not find any cam solenoids in the wiring diagram how it works? and one more question the TGV valve i dont need to use it? is it 100% open when no power to it? Â MVH Sebastian Larsson Quote Link to comment Share on other sites More sharing options...
Cameron Moore Posted August 15, 2011 Report Share Posted August 15, 2011 Hi Sebastian, What version of WRX/STi do you have and what engine is it? Also as Jurgen said can you please post you PCL file so we can check that your settings are correct. -Cameron Quote Link to comment Share on other sites More sharing options...
Sebastian Larsson Posted August 16, 2011 Author Report Share Posted August 16, 2011 Hello! Â the car is a 2001 wrx v7 with ej205 engine, but we use v8 basemap when we start the car, the car dont start with basemap for v7. Â Sebastian larsson Quote Link to comment Share on other sites More sharing options...
Simon Posted August 17, 2011 Report Share Posted August 17, 2011 Attached is the corrected pcl file for the Subaru v7. Changes included: DI 2 pullup resistor changed from on to off Active edge changed from rising to falling Aux output 2 changed from /LH inlet to RH inlet  With these changes the map works on the bench. You will need to check in the run times display (F12) under the VVT tab for more info on what the cam triggers are doing. Quote Link to comment Share on other sites More sharing options...
Sebastian Larsson Posted August 18, 2011 Author Report Share Posted August 18, 2011 Hello  I have tried with these settings but in run time value it is no signal on inlet LH and inlet RH. Sebastian Larsson Quote Link to comment Share on other sites More sharing options...
Jurgen Biggelaar Posted August 23, 2011 Report Share Posted August 23, 2011 Hi Sebastian. I would check your wiring... You should be seeing something in the runtimes signal wise if you have AVCS. Jurgen Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.