Jason Conklin Posted September 25, 2006 Report Share Posted September 25, 2006 I am doing a g2 to work with the integra triggering system.now what i need to know is each sensor have 2 wires. one + and one -. the + i have to connect to the trigger in put which are pin 43 and pin 49 for trigger 1 and 2. but where should i connect the - wires? thanks jason Quote Link to comment Share on other sites More sharing options...
ashesman Posted September 25, 2006 Report Share Posted September 25, 2006 Connect the negative sensor wires to the supplied ground wire in the screened cables (not the braided sheild). I think the wire colours are green and brown (one in each screened cable). Run the screened cable all the way to the pickups if possible for best results. Quote Link to comment Share on other sites More sharing options...
Jason Conklin Posted September 26, 2006 Author Report Share Posted September 26, 2006 i dont have screened cables cause im using a 200mm wire loom to work out an adapter so i will retain my stock wiring and sensors. do you know if i have to connect it to a signal ground or sensor ground the negatives? thanks Quote Link to comment Share on other sites More sharing options...
ashesman Posted September 26, 2006 Report Share Posted September 26, 2006 Connect to the sensor ground wire... or the signal ground back at the ECU. Either way, the sensor ground wire is connected to the signal ground wire just inside the ECU. I would wire to the sensor ground ... thats what its there for! Technically it wont make a lot of difference as long as they are grounded to one of these wires near to the ECU. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.