daniel calderwood Posted May 15, 2008 Report Share Posted May 15, 2008 Hi Ive got a link plus G1 running an SR20DET. the tacho output was working fine in the 1st car i had it in. I have since moved it to a new car and the tacho just wont read. I put a voltmeter on the output wire and its just putting out a constant 12v. Same engine and loom, different car. Any ideas ? Quote Link to comment Share on other sites More sharing options...
Simon Posted May 15, 2008 Report Share Posted May 15, 2008 This is likely to be the Tacho wanting a coil negative signal. The ECU only does a pulsed 0-12V signal. Some Tachos can be modified across. Quote Link to comment Share on other sites More sharing options...
daniel calderwood Posted May 15, 2008 Author Report Share Posted May 15, 2008 I mean i put a meter on the wire out of the link and its reading constant voltage. its not changing with revs like it should do. This is without being connected to the gauge cluster at all. the reading on my hand controller shows fine Quote Link to comment Share on other sites More sharing options...
Simon Posted May 19, 2008 Report Share Posted May 19, 2008 Really need a scope to check the output. To see if it is switching at all. We can bench test if required. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.