trent erceg Posted February 1, 2014 Report Share Posted February 1, 2014 Hi its a 2lt turbo wrx with a g4 plug in. I took it for a stomp today i did have antilag on and as i was nearing home i noticed check light was on and . The fault code list said something about the voltage at the an v9 pin has been above the error high voltage for more than one second. Basiclly i need someone to dumb it down so i can understand what its mean and what i need to do. Thanks trent P.s. antilag was working correctly. And launch control is on the same switch as antilag but wasnt used Quote Link to comment Share on other sites More sharing options...
Kelly Gordon Posted February 2, 2014 Report Share Posted February 2, 2014 You need to look at you PC link file and determine what sensor you have wired up to AN volt 9 (analog #9 voltage) input. Â Once you figure that out you can determine if you need to tweak you error voltages or if you have a failing sensor. Quote Link to comment Share on other sites More sharing options...
trent erceg Posted February 2, 2014 Author Report Share Posted February 2, 2014 Hmm ok so i need to get one of those cables then haha Quote Link to comment Share on other sites More sharing options...
Kelly Gordon Posted February 2, 2014 Report Share Posted February 2, 2014 The cable comes with the ECU.  If you purchased the ECU you have the necessary USB cable. Who tuned your car? Quote Link to comment Share on other sites More sharing options...
trent erceg Posted February 3, 2014 Author Report Share Posted February 3, 2014 Na it didnt i bought ecu second hand . Garry capper at possum bourne motorsport tuned it Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.