Jump to content

An volt 1 error

krishneel Nadan

Recommended Posts

Good morning,

If you open the Analog inputs section of the ECU settings you will see a page called 'Fault Settings' (it is right at the bottom).

In here you can see what your AN volt 1 fault settings are set to. For the majority of inputs a low value of 0.05v and a high value of 4.95v works well.

The warranty on your MAP sensor will likely depend on where you bought it from, I would recommend contacting the seller direct. If it was bought direct from us, please email [email protected]



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...