Jump to content

LINK G3 Rev Limiter


Brett Rodwell
 Share

Recommended Posts

Hi Brett.

I have attached a photo that should explain it (as a picture is worth 1000 words) :)

You will note the drop down selection allowing for soft, hard, AND soft & hard cut.  The hard limit addition is there only when 'soft and hard' is selected.  In this example photo the engine will hard cut 200RPM after it does a soft cut.

The table shows temperature and you fill out what you would like your limit to be at these specific engine temps.  A soft cut feels like an engine cut, and will most likely be enough unless you really need it.  As the hard cut feels like you hit a brick wall.  Your call on that one.

In effect it only needs turning on or adjusting, and this should give you enough ammo to do it yourself.  All you need is a USB printer cable to connect to that ECU, and to download and install this software that this link takes you to (free).

http://www.linkecu.com/support/downloads/pclink-download/PCLinkV3_40

If you are at all not sure about doing this - Please see your tuner!

http://i903.photobucket.com/albums/ac236/linkelectro/G3_limits.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...