Brett Rodwell Posted March 9, 2010 Report Share Posted March 9, 2010 Does the LINK G3 have a rev limiter. I remember reading somewhere that there are two stages of rev limiter. Is this true and can it be installed next time I have it dyno tuned? Quote Link to comment Share on other sites More sharing options...
Jurgen Biggelaar Posted March 10, 2010 Report Share Posted March 10, 2010 Hi Brett. I have attached a photo that should explain it (as a picture is worth 1000 words) You will note the drop down selection allowing for soft, hard, AND soft & hard cut. The hard limit addition is there only when 'soft and hard' is selected. In this example photo the engine will hard cut 200RPM after it does a soft cut. The table shows temperature and you fill out what you would like your limit to be at these specific engine temps. A soft cut feels like an engine cut, and will most likely be enough unless you really need it. As the hard cut feels like you hit a brick wall. Your call on that one. In effect it only needs turning on or adjusting, and this should give you enough ammo to do it yourself. All you need is a USB printer cable to connect to that ECU, and to download and install this software that this link takes you to (free). http://www.linkecu.com/support/downloads/pclink-download/PCLinkV3_40 If you are at all not sure about doing this - Please see your tuner! http://i903.photobucket.com/albums/ac236/linkelectro/G3_limits.jpg Quote Link to comment Share on other sites More sharing options...
Brett Rodwell Posted March 10, 2010 Author Report Share Posted March 10, 2010 Thank you very much!!!! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.