Chipset Posted September 25, 2011 Report Share Posted September 25, 2011 There used to be 3 modes for the Closed loop lamda as there are described in the Link manual . At the last update that i did i can only found : 1 : Stoich2 : Auto  where did WB Closed Loop - In WB Closed Loop mode CLL continually compares the value in the AFR Target Table and the measured AFR from a wideband oxygen sensor controller wired to an Analog Volt channel. Fuel is progressively trimmed in an attempt to match measured AFR with target AFR. · WB Closed Loop Mode 2 - In WB Closed Loop Mode 2 CLL continually compares the value in the AFR Target Table and the measured AFR from a wideband oxygen sensor controller wired to an Analog Volt channel. Fueling is trimmed by a calculated amount using a closed loop control algorithm to match measured AFR with target AFR.  go ? Quote Link to comment Share on other sites More sharing options...
Simon Posted September 27, 2011 Report Share Posted September 27, 2011 The auto mode is an improved closed loop wideband mode that has replaced the old wideband modes. Set to Auto and configure it to use closed loop wideband. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.