Remy van den Hoek Posted October 31, 2008 Report Posted October 31, 2008 Hello, i have a VW corrado with a wire-in Linkplus ems. I wan`t to replace the standard lambda sensor to a wide-band version. Is this possible without modifications to the ecu? Question 2: I have the ecu connected to a laptop, which is connected to a in-dash touchscreen. In the manual it says yould should not leave the ecu connected, because the cable can work as a antenna and interfer with the ecu. I like to have the meter display on while driving. What can i do, so that the cable doesn`t influence with the ecu. Quote
Miika Laitinen Posted February 3, 2009 Report Posted February 3, 2009 Did you get the wideband working on your L+ G1? I'm currently installing my L+ G1 to my Mazda MX-6 V6 and have AEM wideband to go with so I was actually wondering the same question. My car doesn't run yet so I have no idea whether it will work or not. -Mici Quote
Jay Storm Posted February 15, 2009 Report Posted February 15, 2009 I don't see anything in the settings to change the Lambda from narrowband to wideband. That does not mean it can't be done, only that I don't see a way to change it. It would be nice to tune with a wideband instead of the narrowband. Thanks, Jay Quote
cole watson Posted February 16, 2009 Report Posted February 16, 2009 probably doesnt affect you guys but i had to cut a jumper on the curcuit board in the ecu to run a wide band o2 but this is a pnp miata link Quote
Jay Storm Posted February 18, 2009 Report Posted February 18, 2009 I found this thread on page 3.... http://www.linkecu.com/forum/forums/LinkG1Forum/429490685 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.