GT101 Sensor and Boost Control Question

[bill@dentsport]

Hi,

I have recently added two GT101 sensors to each side of the rear of my nissan racecar and am having no luck getting any speed signal out of them. They both receive 8v, sensor gnd and input to DI2 and DI3. Do they need a pull up even though they are self powered?

Additionally, is there a way to run anti-phase boost control with two solenoids with the G4 (it is actually a G3 upgraded to G4 firmware).

Thanks for your help.

-Bill

[Fredrik Pettersson]

Just because the sensor has it's own power supply doesn't mean that it doesn't require a pullup resistor.

Activate it and you should see frequency

as for anti phase wg control i doubt it's doable, maby settings up a gp output table with wg duty cycle as the axis(im on My phone so i din teven know if wg dc is an avaliable axis)

hope it helps