fabiangt79 Posted March 31, 2015 Report Posted March 31, 2015 I have a Subaru V10 wired up to run the ethrottle but after i try to do TPS calibration this error code comes on and the throttle limit is on. Can someone sure some light how to solve this? Quote
Simon Posted April 1, 2015 Report Posted April 1, 2015 Are you using a wire in or is this on the plugin. Most common errors are Target set to TP not FP No PID numbers Motor wired reverse TP main and TP Sub reversed. Quote
fabiangt79 Posted April 1, 2015 Author Report Posted April 1, 2015 The links extreme is wired in. All the common errors you mentioned have been checked and is correct. The issue is once I calibrate the tps the throttle limit comes on. Any other causes? Quote
Simon Posted April 2, 2015 Report Posted April 2, 2015 With the ECU on and the throttle motor turned off / unplugged manually mover the throttle and check the TP main and TP Sub % track each other. If the % is out by more than 3% it will clock errors and then shut down. If these do not track you might have to feed the TP main signal in to both volt inputs so the sub is reading the same TP output. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.