Ed Laurence Posted February 23, 2009 Report Posted February 23, 2009 Hi, I'm running a Link G4 Storm on a 96 MR2 SW20 3SGTE. I rerouted the OEM knock sensor to AN2 and the OEM clutch switch and vehicle speed sensor to DI2 and DI3 respectively (no pull-ups). The next time the ECU went online I had a '5V Supply Error' and because of this ANTemp1, ANTemp2 and throttle position sensors were all offline.... Did I managed to fry something?!!?!? From the documentation, I was under the impression that 12V wouldn't damage any input, DI or AN??? Any help would be greatly appreciated. Thanks, Ed Quote
Guest Dave Posted February 23, 2009 Report Posted February 23, 2009 analoge voltage channels will handle a 12volt input but not a ANtemp channel sounds like you have something shorting to ground on the tps or map wiring possibly i would double check the recent changes you have made Regards David Heerdegen [email protected] Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.