Gerard Murgadella Casado Posted February 14, 2015 Report Share Posted February 14, 2015 Hi. The new G4+ ECU have one problem with bost control frequenci. When set the aux out to Bost solenoide and set the frequenci to 20hz for example and the car is running, this mods working and respond if put more or less frequency but if you swith the ignition off and on again, the number of frequency is correct but the real frequency on solenoide is not the same, go to 10Hz more or less. Please have some solution for or need to configure diferent output? Â Thanks a lot, Quote Link to comment Share on other sites More sharing options...
Scott Posted February 16, 2015 Report Share Posted February 16, 2015 Hi Gerard, I have tested for this problem this afternoon, but have not been able to make it happen. I have a few questions: Which ECU model are you using? Which maincode firmware version are you running? (See Help > ECU Information) Which Auxiliary Output channel is the wastegate solenoid connected to? Are you performing a store after changing the wastegate solenoid frequency and before cycling power to the ECU? Â Scott Quote Link to comment Share on other sites More sharing options...
Simon Posted February 18, 2015 Report Share Posted February 18, 2015 Can you email your PCL file (map) Â also check you do not have any other AUX out set as boost solenoid. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.